Ruger Wrangler issue

Back in Sept I bought a Ruger Wrangler 22 LR just to play and plink with.  I took it to the range and shot several different brands of ammo with it.  The revolver shot any where from 4" to 7" to the right at 20 yds.  I called Ruger and they said that was acceptable!
I watched several videos of guys shooting their Wranglers and they all shot closer to POA than mine.  Ruger refused to do anthing about it so I did myself.
I took a 1/2" washer and cut it in half, closely matched the front sight's profile, painted it flat black then fitted it to the right side of the front sight with a wee bit of PC7 epoxy.
I'll be taking it out tomorrow and see where it hits. Will do finish work on it once its shot.

t

NOTE the above pic it looks like the metal on the sight is not even but it actually is. Also the remaining epoxy cleaned up nicely around the sight.  Anyway, I couldn't wait until tomorrow. I figured after 10 hours the epoxy was set good enough so I grabbed some ammo, the revolver and a target and ran to the nearby woods to see where it hit.  Shooting at 15 yards off hand I was happy.  I'm just a little ticked that I dropped the muzzle at the last shot!  I'd say problem solved. That square bull is 1" square. The bigger hole was caused by the bullet hitting a sticky and knocking it off the target. You can see the 22 hole just o n its edge.

I can’t wait to get out and shoot my Ruger Single Six.  I’m Curious to see what shoots better 22LR or the 22 MAG?  Time will tell.

I had a single six but sold it like a dummy. I'd bet the mag will shoot better.